Question: I have two pocket watches. One is a fusee from 1884, and the other is a chronograph from 1895. Both have been professionally cleaned and adjusted. My problem is this: both watches run fast or slow depending on if they are hung, laid on their back, or laid on a side. Can you advise the best way forward?
Answer: Positional rate inaccuracy is an issue on all watches, particularly watches that are this old. Some watches of poor quality could vary between 5 and 10 per day minutes between positions (or more depending on the condition they are in!)
If they are fine quality watches (typical of railroad watches manufactured after the late 19th century), the manufacturer minimized this rate differential by using high-quality components and masterful engineering. When the watchmaker services the watch today, these watches can be repaired and adjusted to match the original specifications closely. The weight of the balance screws can be adjusted to compensate for positional error. Also, the balance staff’s pivots can be polished or repaired, and the balance jewels may need to be replaced. For that matter, if there is any wear at rotational pivot points (jewels, pivot holes, or pivots) anywhere in the powertrain, it could cause positional timing issues. If the mainspring is incorrect or worn out, this also could cause problems. The hairspring could be bent, off-center, or not level. And the list goes on.